First boot#
The firmware is already on the board. First boot is plugging in the modules, inserting the card, and watching the node name itself and join your mesh. Do all of it on the bench, before the box.
Take the cell out first#
The board is live whenever the cell is in. Take the cell out of the holder before you plug anything into it, and put it back as the last step.
1. The camera#
- Find the ribbon connector marked J2 at the top edge of the board.
- Lift the connector's latch.
- Slide the camera ribbon in with the metal contacts facing down, toward the board.
- Press the latch closed.
2. The motion sensor#
Plug the sensor's 3-pin lead into the connector marked J3. The plug only fits one way.
3. The weather sensor#
Push the BME280 module onto the 4-pin socket marked J10, with the module's pin labels matching the labels on the board.
The microSD card#
The node stores every photo on the card, so the card has to be one the firmware can read.
Any microSD card works, but cards larger than 32 GB must be reformatted FAT32. They ship exFAT, which the camera cannot read. 32 GB and under are usually FAT32 already. Do not use the SD Association's "SD Memory Card Formatter" for a big card: it follows the SD spec and puts exFAT back.
- macOS: Disk Utility, select the card itself, Erase, MS-DOS (FAT).
- Windows: the Explorer format dialog still refuses FAT32 above 32 GB.
Use a third-party FAT32 formatter, or
format /FS:FAT32from a Command Prompt on a Windows 11 build new enough to allow it. - Linux:
mkfs.vfat -F 32 -s 64 /dev/sdX(the whole card, not a partition).
A card the node cannot read looks exactly like a dead board. It is the first thing to check if a node that boots never shows a photo.
4. The card#
Push the card into the slot marked J8 until it clicks. Push again to eject.
5. Boot#
- Check the antenna is still on J9.
- Put the cell back in the holder, positive end at the + mark.
The board boots, names itself, and starts looking for your mesh. Within a few minutes it appears in the app under your gateway.
6. Check it works#
- Take a test photo from the app.
- Wave a hand in front of the motion sensor's white dome. A capture should follow.
- Check the weather readings appear with the photo.
Optional: watch it boot on a computer#
The same USB-C connector (J1) that charges the cell is also a serial console. Connect it to a computer with an A-to-C cable and a USB serial device appears. Open it in any serial terminal and you see the firmware's boot output, ending in the board's identity line.
Dead on arrival?#
If nothing in this chapter happens with a known-good cell, run the three checks under Troubleshooting before emailing. Those three checks are the replacement test.