Battery and solar#
The board runs from one 26650 LiFePO4 cell in the holder on the board. The solar panel keeps that cell charged. USB does not power the board. It only feeds the charger, and with no cell fitted the board does nothing on USB at all. That is why this chapter starts with the cell and ends with USB.
1. Fit the antenna#
Do this before the board ever has power. The radio can be damaged if it transmits with nothing connected.
- Push the small round end of the pigtail onto the connector marked J9 until it clicks.
- Screw the whip antenna onto the other end of the pigtail, finger tight.
2. Fit the cell#
- Check the cell: it must say IFR26650 or LiFePO4, 3.2 V. Put a 3.7 V Li-ion cell back in its box.
- Look at the holder for the + mark.
- Press the cell into the holder, positive end at the + mark.
The holder has reverse-insertion protection. A backwards cell does no harm, but the board will not run until the cell is turned around.
The board boots the moment the cell goes in. Leave it alone for now; the next chapter covers what it does.
3. Charge it from the sun#
A new cell arrives partly charged, at an unknown level. The normal way to fill it is the same way the node will live: on the panel.
- Plug the solar pigtail into the connector marked J6. The plug only fits one way.
- Connect the panel to the pigtail. If the panel has bare leads, match red to the pigtail's + mark.
- Put the panel in a sunny window, or outside, for a day or two.
The panel makes about five times what the node uses, even in poor winter light. A flat cell is full after a couple of days of sun. While it charges, the three small lights at the board edge tell you what is happening; the table is below.
4. Optional: top up over USB#
If you are impatient, or the cell is nearly flat and you want to bench-test tonight, USB fills it in about ten hours. This step is optional. A node that is never plugged into USB cannot have a USB problem.
- Use a USB-A wall charger and an A-to-C cable. Not a power bank, and not a C-to-C cable (see Parts list for why).
- Plug the C end into the connector marked J1.
- Read the lights.
The charge lights#
Three lights sit together at one edge of the board: input, CHG (red) and DONE (green). Four combinations mean something:
| Input | CHG (red) | DONE (green) | Meaning | What to do |
|---|---|---|---|---|
| dark | dark | dark | No power is reaching the board. | It is the cable or the charger, not the board. Try another cable (A-to-C) or another wall charger. |
| lit | lit | dark | Charging normally. | Nothing. |
| lit | dark | lit | Full. | Nothing. |
| lit | dark | dark | The charger is declining to charge. | Charging is blocked below about 0 °C and above about 60 °C. Let the board reach room temperature and try again. If it still declines, email us. |
The same table is in Troubleshooting and on the pinout page.