Deploying#
The node goes outside in a box you drill and seal yourself. Two ports in the lid, one vent, one gland for the antenna, one for the panel cable. About an hour, then an overnight cure.
Why the box needs ports#
Two reasons a camera cannot just sit in a clear box:
- The motion sensor senses heat, and plastic or glass blocks it. It needs an open port with its dome poking through.
- A window sitting a centimetre in front of the lens fogs and hazes every shot. The lens needs its own small window, right up against it.
1. Mark the lid#
All the ports go in the hinged lid, and the board mounts to the inside of the lid. That keeps the lens against its window and the camera ribbon short and still.
- Hold the board against the inside of the lid where it will live.
- Mark the lens centre and the motion sensor centre straight off the board.
- Mark a spot for the vent plug, away from the other two.
2. Drill#
Clamp the lid to a scrap board first. Polycarbonate blows out a crater on the back side of a hole with nothing behind it.
- Lens port: about 13 mm, just wide enough for the camera's field of view.
- Motion sensor port: about 10.5 mm, so the dome pokes through.
- Vent hole: sized to your vent plug.
Low speed on the drill. High speed melts polycarbonate instead of cutting it and welds the chip back into the hole. Back the bit out to clear chips. Deburr every hole on both faces.
3. The lens window#
- Run a thin bead of silicone around the rim only of the acrylic disc.
- Set it on the inside face of the lid over the lens port, so the lid shields the joint from weather.
- Slip the foam ring over the camera's lens barrel. It is a light seal between the lens and the window.
Three things that ruin windows
Use neutral-cure silicone, the "window and door" kind. The vinegar-smelling kind (acetoxy) cracks polycarbonate over time. Never wipe the acrylic disc with alcohol or ammonia glass cleaner; it crazes into a fog. No superglue anywhere near the window; the fumes haze it permanently.
4. The motion sensor#
The sensor is glued in, not screwed.
- Push the white dome through its port from the inside, flush or a hair proud.
- Run a bead of silicone around the base of the dome to hold and seal it.
- Keep the silicone off the white cap. The cap is what the sensor sees through.
5. Mount the board#
- Bond nylon standoffs to the inside of the lid with adhesive. Do not drill through the weather face to mount the board.
- Screw the board to the standoffs with the lens sitting a millimetre or two behind its window.
- Fit the antenna bulkhead pigtail through a gland or a drilled hole in the side of the box, nut on the inside, antenna on the outside.
- Bring the panel cable in through a gland.
Only round cables cross the hinge between lid and base. The flat camera ribbon never does; it cracks from the flexing. Leave a service loop so the lid opens fully.
6. Close it up#
- Drop in the vent plug and a desiccant pack.
- Seat the lid gasket and close the lid.
- Let the silicone cure for a full 24 hours before the node goes outside.
The box is not supposed to be airtight. The vent lets it breathe so it does not fog from the inside; the gasket and the glands keep the rain out.
7. Hang it#
- Mount the node chest high on a tree, facing where the animals move.
- Tilt the lens slightly down and give it a small hood or brim, so rain sheds off the window instead of sitting on it.
- Point the panel at the open sky, south if you can.
A node needs a radio path to a gateway or another node. Trees and hills cost range; height buys it. If the node drops out of the app after hanging, move it, or add a relay between it and the gateway.